Kona
New member
Yesturday I was making a sig the same way I do any other. I used a color balance layer and it worked fine. I saved the sig and then started a new one. This time, after finishing the b/g, I was going to add a color balance layer like I always do after the b/g but when I move the slider for a color the colors dont change, the color just stays black and white (if i use white) Does anyone know what I did to disrupt this from working?
UPDATE: I found out it only works on white, and idk but it also seems to only work with one brush i used, cs-abstract-exsplosion. It might work for other brushes but only if i use white over black for brushing. I still cant figure out why it isnt working the way it should though.
UPDATE: I found out it only works on white, and idk but it also seems to only work with one brush i used, cs-abstract-exsplosion. It might work for other brushes but only if i use white over black for brushing. I still cant figure out why it isnt working the way it should though.